Workflows / LOD 500: the as-built record, checked on site
LOD 500: the as-built record, checked on site
LOD 500 step by step: an element as found or as built, by observation, with its accuracy stated, and how Calq keeps the as-built record element by element, reads point clouds, and hands the building over with its asset register and COBie.
- Available
What LOD 500 means
LOD 500 is not a level above LOD 400. It is a different kind of element: one whose geometry comes from observing what exists or what was built, rather than from a design of what will be. Because it is observed, its accuracy must be stated with it.
The accuracy is usually given as a level of accuracy, the USIBD specification BIMForum recommends: how far a modelled surface may stand from the real one. A record model is only as good as the check behind each element: who looked, when, and how far it stood from the drawing.
Two ways to reach LOD 500
- An existing building surveyed before design: the as-found model the design starts from
- A new building checked as it is built: the design model marked element by element as built as drawn, built otherwise, or not built
Survey an existing building in Calq
- From tape measurements and photos: Calq's own Survey row, or Calq AI "build the existing house from these photos and measurements" (survey_house). Every figure keeps its source: the tape over the photo, a figure read from a photo with its camera.
- From a point cloud: E57, LAS and LAZ are read in the browser and kept beside the model as a reference, drawn in every plan at its cut, every section and the 3D (point_clouds, place_point_cloud). The walls, doors and windows a scan shows can be drafted at a storey (walls_from_point_cloud).
- From drawings: a PDF read whole, sheets, scales and storeys, then built (read_drawing, build_from_drawing); what the document says beyond geometry is kept as the model's sources.
- Mark existing elements with their phase (set_phases), so the design's demolitions and new work are told apart in every view.
Record a new building as built
- Record what was found, element by element: built as drawn, built otherwise, or not built, the day it was seen, by whom, and how far it stands from the drawing in millimetres (record_as_built)
- Read where the record stands: how many elements are verified, deviate, are missing or are not checked yet, by kind and by storey (as_built_status)
- Move a deviating element to where it stands, or keep it where it is and keep the deviation as its note
- Issue the record with its own status and revision under ISO 19650 (issue_revision)
Hand it over for use
- The asset register read live from the model: every asset with its type, its room, its tag and its IFC GlobalId (asset_register)
- Maintenance tasks on each type of asset (set_maintenance, maintenance_plan)
- Documents linked to assets: manuals, warranties, certificates (link_asset_document)
- COBie and IFC for the owner's systems, from the same model
Questions
Is LOD 500 more detailed than LOD 400?
Not necessarily. LOD 500 says how an element's geometry was obtained, by observation, and how accurate it is. An LOD 500 element can be simple if that is what was asked for.
How do I state the accuracy of an element in Calq?
Record each check with record_as_built: the day, the person and how far the element stands from the drawing. For a scanned building, the point cloud stays beside the model as the reference the elements were read from.
Can Calq read a laser scan?
Yes. E57, LAS and LAZ files are read in the browser, kept as a reference beside the model, drawn in plans, sections and 3D, and the walls, doors and windows a scan shows can be drafted at a storey.