Workflows / Zoning and plot rules check
Zoning and plot rules check
Give a plot its rules in Calq (setbacks, height, storeys, coverage, floor area ratio, parking) and the designed building is measured against each one, on the plan and in a statement.
- Available
What it is
A plot in Calq carries its own rules: the setback from the street, the sides and the rear, the greatest height and number of storeys, the coverage, the floor area ratio and the parking it must hold. They are the plot's, typed from its own planning sheet: nothing is filled in by default.
The building as designed is then read against them. Each storey's outline is taken from the model, so the coverage, the floor area and every distance to the plot line are measured, not typed.
How it goes
- Draw the plot or take it from the map, and mark the side the street is on
- Type the plot's rules, or ask for a published rule set by its name
- Fit a massing to the zoning envelope, or design the building
- Read the check: each rule with the measured value, the limit and whether it is met
- See the setback line and every broken setback drawn on the plan
What is checked
- Coverage of the plot, on the ground storey and on the upper storeys
- Floor area ratio
- Front, side and rear setbacks, each as the shortest distance to that side
- Number of storeys and the height of the building
- Parking spaces, as a count
- Where the plot gives them: the roof annex, the parapet, the floor level and the boundary wall
Published rule sets
Where an authority publishes one set of rules for a kind of building, Calq can hold it as data: every figure with the clause it was read in, the document and its address. Calq holds Saudi Arabia's requirements for residential villas (Ministry of Municipalities and Housing, 2024), worked out from the plot's own area and street width.
A set is applied only when you ask for it by name, and the plot then says which set and which document its rules came from. A plot's own sheet always wins.
What you get
- The list of rules with pass, fail, not given or not measured for each
- A site plan with the setback line, the shortest line to each side with its length, and the street with its width
- A statement of rules, areas and coverage storey by storey, setbacks and parking, in the model's language
- The same check beside the building code check, in one panel
Good to know
A rule the plot was not given, or one that could not be measured, is never shown as a pass. The check is a pre-check, never a certificate: the authority decides.
Typing a plot's rules and fitting a massing to the zoning envelope are on the free account. The check of the designed building against the plot rules is on Studio; what each plan holds is on calq.live/pricing.
Questions
Can Calq check a building against zoning rules?
Yes. Calq measures the designed building against the plot's rules: coverage, floor area ratio, setbacks, storeys, height and parking. It is a pre-check, never a certificate.
Where do the zoning figures come from?
From you: the rules are the plot's own and nothing is defaulted. A published rule set is applied only when you name it, with the clause each figure was read in.
Does Calq measure setbacks from the model?
Yes. Each setback is the shortest distance from the storey's outline to that side of the plot, drawn on the site plan with its length.
What happens when a rule is missing?
It is listed as not given. A rule that was not given or not measured is never counted as met.
Does Calq hold Saudi villa plot rules?
Yes. The Ministry of Municipalities and Housing's 2024 requirements for residential villas are held as a published rule set, each figure with its clause, applied when you ask for it by name.
Can I fit a massing to the zoning envelope?
Yes. Massing fitted to the floor area ratio and the zoning envelope is on the free account.